1.产品概述(General Description)(1) 型号含义

(2) 产品标准:本产品性能符合GB4109-88标准。

(Executive stand:GB4109-88.)

(3) 用途:本系列套管为环氧树脂APG工艺压力凝胶成型结构，它适用于额定电压为12KV、35KV及以下成套设备中，作为绝缘隔离和联接过度用。

(Purpose:Tish series bushing is formed by epoxy resin with APG technics，it isused for insulation and connection transition of completes with rated voltage of 12KV，35KV and below.)

(4) 结构简介:套管耐污及潮湿，无需特别维护，只需定期地清除表面污物。安装时，母排从中穿过。

(Structure:The busing is anti-pollution，moisture resisture and maintenance free，it only needs to clean the dietiness on surface at interval time.The bus is put through during installation.)

2.使用条件(Operation Condition)

(1)户内装置

(Indoor installation)

(2)海拔高度不超过1000M

(Altitude:≤1000m;)

(3)周围气温+40℃~5℃;

(Ambient temperature:+40℃~5℃;)

(4)当空气温度+20℃时，相对湿度布超过85%

(The relative humidity shall not be more than 85%at+20℃ ambient temperature;)

(5)无严重影响触头盒绝缘的气体、蒸汽、灰尘及其它爆炸性和腐蚀介质的场所。

(NO gas ，wapor or dust that may severely affect the insulation of contact box，no explosive or corrosive substance.)

3.产品规格及技术参数(Specification & Technical Parameter)

(1) 额定电压:0、35KV;

(Rate voltage:10、35KV;)

(2)最高电压:12、40.5KV;

(Maximum voltage:12、40.5KV;)

(3)应能承受工频耐压(有效值)42KV、95KV、5min;雷电冲击耐压电压(峰值):75KV、185KV(注:95KV/185KV为35KV套管试验值

(Power frequency withstand voltage (effective value) :42KV、95KV、5min;lightning impulse withstand voltage (peakval-ue) :75KV、185KV (Note:95KV/185KV is test value of 35KV bushing) )

4.套管外形及安装尺寸。(See attached figure for installation dimension of bushing.)

180x110-194套管

欧式穿墙套管

套管100X145X218

套管128-100X100-246

套管140X200-197

套管140X200X230

套管152X152X260

套管210-125X125-233

高压穿墙套管CWB-35/630A

高压穿墙套管CWWL-20/3000A

高压穿墙套管CWC-10/2000A

高压穿墙套管CWWC-20/1000A

高压穿墙套管CB-10/200-630A

高压穿墙套管CWC-10/2000A