ISO 15105-2、 GB/T 19789、 ASTM D3985、 ASTM F2622、ASTM F1307、 ASTM F1927、 JIS K7126-B、 YBB 00082003
包装材料氧气透过性试验方法内容简介 :
1.范围
本标准规定了在稳态下包装材料氧气透过性试验方法-库仑计检测法。
本标准适用于塑料薄膜、薄片、复合材料、塑料复合纸、塑料涂覆织物等包装材料的氧气透过性的测试，可以测定包装材料的氧气透过率、氧气透过量、氧气透过常数等。
2.规范性引用文件
下列文件中的条款通过本标准的引用而成为本标准的条款。凡是注日期的引用文件，其随后所有的修改单(不包括勘误的内容)或修订版均不适用于本标准，然而，鼓励根据本标准达成协议的各方研究是否可使用这些文件的最新版本。凡是不注日期的引用文件，其最新版本适用于本标准。
GB/T2918塑料试样状态调节和试验的标准环境
GB/T6672塑料薄膜和薄片厚度的测定机械测量法
3.术语和定义
下列术语和定义适用于本标准。
3.1
稳态steady-state
当试样吸收的气体数量与透过试样的气体数量达到平衡时的状态。
3.2
氧气透过率oxygentransmissionrate,02GTR
在试验条件下，在单位时间内透过单位面积试样的氧气数量。
在标准温度和压力下
范围:1.1 This test method covers a procedure for determination of the steady-state rate of transmission of oxygen gas through plastics in the form of film, sheeting, laminates, coextrusions, or plastic-coated papers or fabrics. It provides for the determination of (1) oxygen gas transmission rate (OTR), (2) the permeance of the film to oxygen gas (PO2), and (3) oxygen permeability coefficient (P'O2) in the case of homogeneous materials. 1.2 This test method does not purport to be the only method for measurement of OTR. There may be other methods of OTR determination that use other oxygen sensors and procedures. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory
ISO 15105-2 现行标准测试报告示例图。
