试验方法及要求 Tests
高温贮存 Shelf Life | +105℃ 贮存1000小时后,加额定工作电压30分钟,电容器应满足以上耐久性要求 After storage for 1000 hours at +105℃, UR to be applied for 30 minutes ,the capacitors shall meet the requirement of load life above | |||||||
低温特性 Low Temperature Stability 阻抗比 Impedance Ratio (120Hz) | UR (V) | 6.3 | 10 | 16 | 25 | 35 | 50 | |
Z(-25℃)/Z(+20℃) | 2 | 2 | 2 | 2 | 2 | 2 | ||
Z(-40℃)/Z(+20℃) | 4 | 4 | 3 | 3 | 3 | 3 | ||
耐焊接热 Resistance to Soldering Heat | 在260℃的条件下,电容器在热板上保持10秒,然后从热板上取出电容器,让其在室温下恢复,电容器应满足以下要求:The capacitors shall be kept on the hot plate maintained at 260℃ for 10 seconds. After removing from the hot plate and restored at room temperature, they meet the following requirement. | |||||||
电容量变化率 Capacitance Change | ±10%初始值以内 Within ±10% of the initial value | |||||||
损耗角正切(tgδ) Dissipation Factor | ≤初始规定值 Not more than the initial specified value | |||||||
漏电流 Leakage Current | ≤ 初始规定值 Not more than the initial specified value |